How To Clean Your Shower Doors With 2 Simple Ingredients

There is one area of our bathroom that always makes me cringe when I look at it. It’s our shower doors and tracks and the limescale and mineral deposits that had built up on them. Here is the blunt truth and no judging but I have never really cleaned around the shower frame or door tracks. How to clean shower door tracks? I really wasn’t sure.

Years of Neglect
So I’m pretty sure when we moved into our house years ago that there was already some buildup on the shower door frame and tracks. That combined with not knowing how to clean it or even if it could be cleaned and honestly, a little laziness, I just tried to ignore it. However, I finally realized that I needed to try to tackle it. Below you will find my process and results.

Starting Point
I tried to take some before, during and after pictures. I don’t feel like they fully capture the essence of the task at hand but I will give you one picture to start to give you an idea of what I was in store for.

I did some research online looking for the best method (and easiest) to remove the build-up. I decided to start with the vinegar method. It seemed the simplest and I already had vinegar on hand so off I went.

Step 1 – Vinegar
The first step was to pour vinegar into the shower tracks. My tracks have little holes to allow the water to drain out so I plugged those with paper towels. That wasn’t the perfect solution as it still drained out once the paper towel was soaked but it did a good enough job. A rag or something thicker than a paper towel may work better.

Dirty Shower Door Tracks #dirtyshower #cleanwithvinegar

After I let the vinegar sit for about 30 minutes, I removed the paper towels blocking the drain holes. Then I grabbed a clean paper towel and wiped out the tracks. Most of the grime and stains from within the shower door tracks were removed with that one swipe! I grabbed a toothbrush and scrubbed the hard to reach places that I couldn’t reach with the paper towel. (If you don’t have an old toothbrush, I found a multi-pack for a $1 at Walmart). There was still a little area under the door in the track that I couldn’t reach with the toothbrush. For under the doors, I used a paper towel soaked with vinegar and gently shoved it under the door in the track. Since I already had let the vinegar sit in the tracks, the grime was already loosened so it didn’t take much to clean it.

For the vertical tracks, I soaked some paper towels with vinegar and shoved them into the tracks and let them sit. As I removed the paper towels, I wiped down the tracks as I removed them and then used the toothbrush again for the tight corners.

Step 2 – Baking Soda
Now, I moved on to tackle the mineral build-up on the top and outside of the shower door tracks, as well as some vertical part of the tracks. I really didn’t know if they would be able to come clean but I was going to give it my best shot.

Shower Door Tracks Calcium Buildup #showerdoordirt #showertrackcalciumdeposit

I mixed some baking soda with water in a little bowl to make a paste. Using a rag, I applied the paste to the build-up on the top and outside of the track and in the vertical section of the track and let it sit there. I don’t remember how long I let it sit there as I was working on other things but I would say probably 30 minutes. I wiped off the paste with a wet rag and surprisingly, quite a bit came off in the first swipe. If your doors don’t have a lot of build-up like mine did (and I’m sure they probably don’t), you might be done with that initial cleaning.
Shower Door Track Buildup #howtoremovecalcium #howtocleanshowerdoortracks
After cleaning my shower door tracks #cleanwithbakingsoda #cleanwithvinegar

Unfortunately, due to my lack of cleaning, this task was going to take some elbow grease. I repeated the baking soda step over again. This time instead of wiping it off with a wet rag, I used a little metal scraper and scraped the mineral deposit build-up. Some areas required more than others, especially the top of the shower door track right section next to the wall. Since that one spot had so much build-up, I actually had to chip away at it with the metal scraper. I repeated with baking soda over and over until finally the build-up was gone!

After cleaning the outside of the shower door track – #finallyclean #cleanmyshowerdoors

Shower Doors
Again, I started with the vinegar. I poured some into a spray bottle and sprayed the vinegar at the top of the build-up and let it run down the grime. I also used the baking soda paste to remove the grime and build-up that was still left on the metal edges of the shower doors. Just as I did with the shower door tracks, I applied the paste to the door and let it sit. Then I wiped and scraped off the build-up from the shower door corners and along the bottom of the door. Thankfully, this was not anywhere near as bad as the tracks so I only have to repeat it once.

Dirty Shower Door Buildup #removeshowerdoorbuildup #howtocleanshowerdoors

Clean Outside of Shower Door #cleanshowerdoor #cleanwithvinegar

**Disclosure** You may notice in the after picture that there is still some build-up on the door and edge. I had to stop to pick up my kids at school, so I will need to finish it on another day.

Rinse
After I finally got the limescale and mineral build-up off, I washed everything down. I gently poured water into the tracks to remove any leftover dirt and grime being careful to not overflow the tracks. I used a clean, wet rag to wash everything else.

Final Tips
One of the benefits of the vinegar and baking soda method is that they are natural cleaners. I figured since they were natural, I wouldn’t need gloves. Through my lengthy cleaning process, I learned that while they are natural, gloves would have been a good idea. At the end of the day, the skin on my fingertips was incredibly dry and peeling. While this obviously isn’t a r